Welcome to the ADSL client setup. First, I will run some checks on your system to make sure the PPPoE client is installed properly...
The following DSL config was found on your system:
Device: Name: ppp0 DSLppp0
Please enter the device if you want to configure the present DSL config (default ppp0) or enter 'n' if you want to create a new one: 建立的拨号连接名字,默认就行
LOGIN NAME
Enter your Login Name (default ): 输入ADSL账号的登陆用户名
INTERFACE
Enter the Ethernet interface connected to the ADSL modem For Solaris, this is likely to be something like /dev/hme0. For Linux, it will be ethX, where 'X' is a number. (default eth1): ADSL设备所绑定的网卡,我们这里是eht1
Do you want the link to come up on demand, or stay up continuously? If you want it to come up on demand, enter the idle time in seconds after which the link should be dropped. If you want the link to stay up permanently, enter 'no' (two letters, lower-case.) NOTE: Demand-activated links do not interact well with dynamic IP addresses. You may have some problems with demand-activated links. Enter the demand value (default no): 默认就行
DNS
Please enter the IP address of your ISP's primary DNS server. If your ISP claims that 'the server will provide dynamic DNS addresses', enter 'server' (all lower-case) here. 注意这里我们不要填写任何DNS地址,后面我们会配置ADSL自动从ISP中获取dns地址 If you just press enter, I will assume you know what you are doing and not modify your DNS setup. Enter the DNS information here:
PASSWORD
Please enter your Password: 输入ADSL账号的密码 Please re-enter your Password: 密码验证
USERCTRL
Please enter 'yes' (two letters, lower-case.) if you want to allow normal user to start or stop DSL connection (default yes): 默认就行
FIREWALLING
Please choose the firewall rules to use. Note that these rules are very basic. You are strongly encouraged to use a more sophisticated firewall setup; however, these will provide basic security. If you are running any servers on your machine, you must choose 'NONE' and set up firewalling yourself. Otherwise, the firewall rules will deny access to all standard servers like Web, e-mail, ftp, etc. If you are using SSH, the rules will block outgoing SSH connections which allocate a privileged source port.
The firewall choices are: 0 - NONE: This script will not set any firewall rules. You are responsible for ensuring the security of your machine. You are STRONGLY recommended to use some kind of firewall rules. 1 - STANDALONE: Appropriate for a basic stand-alone web-surfing workstation 2 - MASQUERADE: Appropriate for a machine acting as an Internet gateway for a LAN Choose a type of firewall (0-2): 由于我们要在后面使用iptables,所以选择2
Start this connection at boot time
Do you want to start this connection at boot time? Please enter no or yes (default no): 我这里不是包月,所以选择no,如果你是包月的话就选yes
** Summary of what you entered **
Ethernet Interface: eth1 User name: username Activate-on-demand: No DNS: Do not adjust Firewalling: MASQUERADE User Control: yes Accept these settings and adjust configuration files (y/n)? 选择yes,保存设置.
粤ICP备06047689号
本文地址：
返回
